I received this question yesterday...
MJ
Could you explain the phenomena of back-flow inside the mold? I have in-mold sensors, but I don't think I am seeing this.
My Response
Basically, there are two areas within the molding process where back-flow typically occurs:
1) Transfer From Fill To Pack: If the mold is completely full during first stage, the mold will begin to pressurize as the machine tries to continue pack the mold with first stage fill. When the machine transfers to pack using a lower pressure, a little amount of the pressurized material within the mold will tend to back-flow. In some cases, this back flow will cause sinks or voids on the molded part... in other cases, you may see delamination occur. If you are using a pressure monitoring system, you may see a sharp drop in cavity pressure at the point where the machine transfers from fill to pack, especially near the gate.
2) At The End Of Pack: Insufficient packing time results in a gate which is not completely sealed. As a result, some of the pressure in the mold cavity will become relieved by a small back-flow of material across the gate into the runner system. This most often results in sinks or voids near the gate area. If you are using a pressure monitoring system, you should see a significant drop in pressure at the cavity pressure sensor near the gate when the packing pressure times out.
Additional Thoughts
Keep in mind... if your process is properly established, you should notice a nice gradual rise and fall of pressure within the mold cavity and little to no back-flow within the mold cavity.
-Andy
Hello Andy.
I have this kind of problem on one product. It looks like weld line. But when I overfill the cavity weld line disapear, but after that I have flash. How I can solve this problem?
Milan
I do not have full knowledge of the application, but there are two things that immediately come to mind:
1) Ensure the screw does not bounce-back during transfer from fill to pack
2) Compare your mold and melt temperatures to your documented standard
-Andy
Hello Andy.
My screw is doing bounce-back during transfer, but I saw this feature during using fast injection speed in process without problems. How can I eliminate bounce-back? I know, that with lower speed, bounce-back disappears but after that I have short shot on living hinge.
Milan
Whenever you decrease your fill, you will usually have to increase your packing pressure to compensate. You will most likely have to find a balance between between the two conditions. You may also need to use one packing pressure to complete fill, and another to hold until gate seal to compensate for the flash condition.
-Andy
thanks Andy
Milan